Log in


Chill Upgrade Membership Ludicrous Plaid!
  • Home
  • Wall Connector Gen 3

Wall Connector Gen 3

  • February 01, 2021 12:49 PM
    Message # 10053702

    I recently installed a Gen 3 wall connector.  Seems to work fine.  Two questions:  1.  Is there a way to access the activity of the wall connector, note the firmware etc.  2.  When I installed it, and connected to wifi, it came up partially configured.  Seems to work fine, but what does that mean, do I need to do anything about it.

COPYRIGHT © 2020 TOCNYS. ALL RIGHTS RESERVED.

TESLA OWNERS CLUB NEW YORK STATE IS AN INDEPENDENT ENTHUSIAST ORGANIZATION AND IS NOT AFFILIATED WITH TESLA MOTORS, INC. OR ITS SUBSIDIARIES, TESLA, MODEL S, MODEL X, MODEL 3, POWERWALL AND THE "TESLA", "T" AND "TESLA AND T FLAG" DESIGNS, AND CERTAIN OTHER MARKS, ARE TRADEMARKS OR REGISTERED TRADEMARKS OF TESLA MOTORS INC. IN THE UNITED STATES AND OTHER COUNTIES. READ OUR PRIVACY POLICY.

Email: info@tocnys.org
Phone: (518) 218-6715

Address:
1260 Lyell Ave
Rochester, NY 14606

Powered by Wild Apricot Membership Software